● With normal cooling water No-load up to -32 ° C ~ -40 ° C, dew point, with the cooler no-load case, even up to -40 ° C below the dew point;
● dehumidification and regeneration continuous cycle work to ensure that the dew point temperature into a straight line;
● Ceramic fiber as the substrate honeycomb wheel, good dehumidification effect;
● do not produce pollution to ensure the quality of plastic;
● runner can produce 1000 ° C high temperature to prevent fire, acid and alkali, the average life expectancy of 3-8 years;
● Regeneration temperature of 180 ° C, than the traditional hot air dryer to save 2/3 time and 30-40% of the energy;
● A dehumidifier can be used with several independent dry hoppers.
Hengrong brand honeycomb wheel dehumidification drying series is mainly for strong hygroscopic engineering plastics, dehumidification and efficient industrial design and development of products. How to strictly control the moisture in raw materials, is the key to processing high-quality plastic products.
This series of models are based on ceramic fibers as the core material of the honeycomb wheel, which represents the highest technological achievement in the world. Therefore, the dry air provided can easily reach a dew point of 32 ° C ~ -40 ° C, ideally more Achieve below -40 ° C, and the dew point temperature stability, to ensure the molding of plastic products of high quality and stability. Full range of P.I.D temperature control system standard equipment; control with LED liquid crystal display, the maximum drying capacity of the product up to 6000m? / hr.